Latest Questions
Post Top Ad
Your Ad Spot
Monday, June 17, 2019

16 Top Phlebotomy Interview Questions and Answers {Updated}

Phlebotomy Interview Questions and Answers for experienced PDF, Read commonly asked Phlebotomy Job Interview Questions with Answers PDF for Freshers.


Read Phlebotomy Interview Questions and Answers

Explain what is the Vacutainer blood collection system?
The Vacutainer system contains a double pointed needle, a plastic holder and a series of vacuum tubes with rubber stoppers of various colors. The color indicates the type of additives. It is the best way of collecting blood into the sample tube for analysis in the laboratory. It is easy and safe to use as the blood sample will directly go into the appropriate test tube rather than collecting blood first and transferring to the tube.


How Vacutainer needle is different from a normal syringe needle?
Vacutainer needle has a sharp point at both ends and usually covered by a rubber sheath, with one end being shorter than the other.


Explain what is the basic technique to collect blood?
To collect the blood sample the basic technique include
• Tie the belt (tourniquet) around the upper arm and about 2-3 inches above the venipuncture site
• Make sure that your belt does not lose the grip from hand
• It will exert pressure on the vein, and your vein will emerge out clearly.
• Palpate the vein and locate the best site for blood collection
• Always wear gloves while performing these activities
• Apply a disinfectant to sterile the site of collection
• Now insert syringe with the correct angle, and draw the blood out and collect it in a sample tube
• Once you collect the blood, never forget to loosen the belt from the patient arm, otherwise, it will spill blood all over.


What are the different sizes of Vacutainer Tubes available?
Different Sizes of Vacutainer Tubes available are
• Adults: 5,7,10 and 15 mL
• Pediatrics: 2, 3 and 4 mL


What are the types of anti-coagulants used by Phlebotomy?
• EDTA
• Sodium polyanetholesulfonate
• Potassium EDTA
While some also use Heparin as an anticoagulant


Give all information that should be mentioned on the label of the sample tube?
Sample tube should have all the information like
• Patient’s Information’s ( first, middle and surname)
• Patient’s ID number (Note: The above-given information must match the same on the requisition form)
• On the label of each tube date, time and initials of the phlebotomist must be mentioned on the tube


Explain what is thrombin time?
Thrombin time is a screening of coagulation time, where the time is noted to form fibrin from fibrinogen in plasma. Normal, thrombin time is less than 20 seconds.


Explain what one should do in case of incomplete collection or no blood is obtained?
If you fail to collect blood after puncturing, then in such a situation, you have to do the following things
• Change the position of the needle and move it forward
• Or move it backward, if it has penetrated too far
• Set the needle at the correct angle, the bevel may be against the vein wall
• Loosen the belt, it may be suppressing the blood flow
• Use another tube
• Re-anchor the vein, vein sometimes slip away from the point of the needle
Even trying all this technique does not help then try another puncture at another site.


Explain how you collect a blood sample in an infant?
Usually, to collect a blood sample from infant, blood should be collected from the foot, from the heel region.
• Pre-warm the infant’s heel, not too much that it hurts the infant ( 35-40 degree C) for 3-5 minutes, it increases the blood flow and helps to detect blood capillaries easily
• Puncture the site with a sterile lancet
• Never use the central portion of the foot or too wide of the heel
• Puncture across the heel print lines
• With a clean and dry cotton, piece wipe away the first drop of blood and collect the sample from the second drop of blood
• Again apply some sterile solution to the puncture site to stop bleeding


Explain what is Whole Blood sample?
A Whole Blood sample is referred to as blood that is drawn and mixed immediately with an anticoagulant to maintain the characteristics of the blood cells and prevent clotting, allowing whole blood analysis to be done. In short, the blood that is not allowed to clot after collecting from the patient is referred to as whole blood sample.


What are different color tubes used in phlebotomy and what does it indicate?
The sample tube or blood collection tube has a different color top on it which indicates what test needs to be done on it.
• Red Top: Immunology and Serology testing
• Golden Top: Immunology and Serology testing, but use different chemicals to perform the test
• Light green Top: For Chemical testing
• Red gray Top: For Chemical testing but use different chemical then Light green top
• Purple Top: Hematology testing
• Light blue Top: Coagulation tests
• Dark green Top: For whole blood testing using heparin
• Dark blue Top: For whole blood testing using EDTA
• Light Gray Top: Blood sugar testing
• Yellow Top: DNA testing, paternity testing, and HLA tissue testing
• Yellow black Top: Microbiological testing ( Aerobes, anaerobes, and fungi)
• Black Top: For testing like Westergren Sedimentation Rate
• Orange Top: STAT serum chemistries
• Brown Top: Serum lead determination


What tests are commonly performed for checking kidney functions?
For checking kidney functions the tests performed are
• Creatinine test: High level of creatinine in urine indicates kidney may not be working properly
• Urea: High level of urea in urine indicates kidney may not be working
• eGFR (Estimated Glomerular Filtration Rate): Normal value of eGFR is 90-120 ml/min, anything below 90 ml/min suggests there are some kidney problems
• Dissolved Salts: Sodium, potassium, chloride, and bicarbonate are an electrolyte, any alteration in the level of this electrolyte may be due to the kidney dysfunction


Explain what is the HIV test window period?
HIV test window period is the time interval between the original infection with HIV and the appearance of detectable antibodies to the virus. The window period is about 14-21 days, while in some case up to 12 weeks. In other words, a blood sample from HIV patient will show no sign of HIV infection if he/she is in the window period, and his blood will show all HIV test negative, till it surpasses the window period. It’s only after the window period, you will able to detect the virus in the blood sample and see the infection in the blood sample of the HIV patient.


How soon you able to detect whether the patient is infected by HIV if he is in the “Window Period”?
If HIV patient is in Window Period there is a different level of test, they are
• First generation Test: They can detect antibodies after 40-60 days of infection
• Second generation Test: They can detect antibodies after 21-24 days of infection
• Third generation Test: They can detect antibodies after 14-15 days of infection


Explain what are the possible risk that is associated with arterial sampling in neonatal?
• The collapse of veins if the tibial artery is damaged while puncturing the medial aspect of the heel
• Osteomyelitis of the heel bone
• Possibilities of nerve damage if the fingers of neonates or infants are punctured
• Hematoma
• Scarring
• Generalized or localized necrosis

Post Top Ad

Your Ad Spot

Pages